Tramex DEC SCANNER - Scanneur d'humidité toit terrasse.
    Tramex DEC SCANNER - Scanneur d'humidité toit terrasse.
    Tramex DEC SCANNER - Scanneur d'humidité toit terrasse.
    Home Disponible sous 24 h Fiche produit PDF

    Tramex INSPECTOR PACK - Wall and roof humidity scanner

    Reference:
    HT €1,540.00
    TTC €1,848.00

    The Tramex Roof and Wall Kit detects and evaluates humidity conditions in roof and wall systems by non-destructively measuring electrical impedance. A low-frequency electronic signal is transmitted into the material being tested via electrodes located at the base of the instrument.

    Configurez votre produit

    Quantity

    Add to favorites Add to compare
    Paiement sécurisé — CB, Visa, Mastercard, PayPal
     

    Paiement sécurisé

    Transactions protégées et données confidentielles.

     

    Livraison 24-48h

    Expédition express depuis nos ateliers à Toulouse.

     

    SAV atelier France

    Réparation sous 48h — concepteur français depuis 2004.

    Tramex® INSPECTOR PACK

    Roof and wall kit — non-destructive humidity detection by electrical impedance

    The Tramex Roof and Wall Kit detects and evaluates humidity conditions in roof and wall systems by non-destructively measuring electrical impedance. A low-frequency electronic signal is transmitted into the material being tested via electrodes located at the base of the instrument.

    The intensity of this signal varies depending on the amount of moisture present in the material being tested. The Tramex floor and wall leak detector determines the current strength and converts it into a comparative moisture content value, displayed on a clear large analog dial.

    Usage procedure

    Moisture testing can be performed during installation, as part of a regular maintenance program, or before repairing damaged roof and wall systems. The Tramex kit is a portable and robust set, featuring two modes of operation: one for roofs and one for EIFS/foam insulation systems, each providing two levels of signal penetration. Once the Tramex is calibrated to an area known to be sufficiently dry, it provides instant readings for moisture inspection.

    Tramex INSPECTOR PACK kit — case, RWS scanner, CMEX5, IRT2 thermometer and accessories
    Standard Walls and Roofs Pack — complete kit in its Tramex carrying case

    Pack contents

    Tramex RWS roof and wall scanner — roof and wall humidity detector

    1/ The humidity detector

    The Tramex Roof and Wall Scanner is an instantaneous, accurate, multi-mode, non-destructive impedance scanner for assessing moisture conditions in roofing (per ASTM D7954), EIFS, foam insulation systems and other building envelope applications.

    Multi-mode function allows deep penetration and sensitivity selection. It helps trace leaks and locate their source — a major asset for walls and roofs.

    Tramex Concrete Moisture Encounter CMEX5 — digital moisture tester

    2/ The humidity tester

    The Tramex Concrete Moisture Encounter CMEX5 is a non-destructive digital concrete moisture tester for measuring the quantitative moisture content of concrete floors and slabs. It incorporates a hygrometer measuring ambient relative humidity, temperature, dew point and environmental humidity ratio.

    A pluggable bayonet port allowsuse optional wooden pin probes or Tramex Hygro-i2 sensors to measure the relative humidity of concrete in accordance with ASTM F2170. Instant and precise quantitative measurement.

    3/ The infrared thermometer

    The IRT2 is a portable, non-contact dual-laser infrared thermometer with a 12:1 distance-to-point ratio and audible and visible high/low set point alarms. It measures surface temperatures from -50°C to 650°C with an accuracy of approximately 1-1.5%. Response time 0.15 s, 9V battery power supply, compliant with EN60285 class II laser standard.

    Tramex electrode with pins — wall humidity measurement

    4-6/ Probe and pin

    4/ Heavy-duty Tramex Electrode with 200 mm long insulated pins, for use with CMEX5 and MEX5.

    6/ Hygro-i2® Humidity Probe — thin, durable wand ideal for measuring relative humidity, temperature and dew point in tight spaces or wall structures. CMEX5, MEX5 and RHTX compatible.

    Hygro-i2 Tramex probe — in-situ measurement in concrete

    5/ Hole punch

    To create pilot holes for long pin probes in EIFS and roofing systems.

    Tramex Extendable Pole — Detector Extension Handle

    7/ Extendable pole

    Extension handle for the Tramex floor and wall leak detector — comfortable inspection of large areas without bending.

    Tramex Meters application — CMEX5, Hygro-i2 probe and data logging
    Tramex Meters app — diagnostic data retention
    Tramex Concrete Moisture Encounter with wall pole
    Extensible pole — measurement on vertical surfaces

    It is possible to download the Tramex Meters application to store data during diagnostics.

    Need to scan large roofs?

    For continuous inspection of large surfaces of flat roofs, discover the Tramex DEC SCANNER — smobile canner on wheels conforming to ASTM D7954.

    Secure payment guaranteed on our site — Visa, Mastercard
    Need financing? Long-term rental with purchase option — 05 61 42 90 63

    The AGM TEC Toulouse commitment

    • Expert Support: Technicians based in Bessières — 05 61 42 90 63
    • Reactive after-sales service: Integrated workshop — repair within 48 working hours
    • Permanent stock and demonstrations in Bessières — Tramex distributor in France
    Type de kitPack Standard Murs et Toitures — Roof & Wall Inspector Kit
    Principe de mesureImpédance électrique basse fréquence — non destructif
    ApplicationsToitures, murs, EIFS, isolation mousse, enveloppe du bâtiment
    Scanner RWSMultimode — norme ASTM D7954 — 2 modes (toiture / EIFS) × 2 niveaux de pénétration
    Testeur CMEX5Mesure quantitative humidité béton — hygromètre intégré — norme ASTM F2170 (avec Hygro-i2)
    Thermomètre IRT2Infrarouge sans contact — -50 °C à 650 °C — rapport 12:1 — réponse 0,15 s
    ÉlectrodeBroches isolées 200 mm — compatible CMEX5 et MEX5
    Sonde Hygro-i2®HR, température, point de rosée — espaces étroits et structures murales
    AccessoiresPerforatrice, perche extensible, mallette de transport
    Application mobileTramex Meters — enregistrement et suivi des diagnostics
    CalibrationSur zone sèche de référence — lectures instantanées ensuite
    Poids21 kg

    FAQ — Tramex® PACK INSPECTEUR

    À quoi sert le PACK INSPECTEUR Tramex ?

    Le PACK INSPECTEUR évalue les conditions d'humidité dans les toitures et murs par mesure d'impédance non destructive. Idéal pour l'installation, l'entretien préventif et le diagnostic avant réparation.

    Quelle différence avec le Tramex DEC SCANNER ?

    Le PACK INSPECTEUR est un kit portatif pour mesures ponctuelles sur murs et toitures. Le DEC SCANNER est un scanner mobile sur roues pour couvrir rapidement de grandes surfaces de toits plates.

    Que contient le pack Standard Murs et Toitures ?

    Scanner RWS, testeur CMEX5, thermomètre IRT2, électrode 200 mm, sonde Hygro-i2®, perforatrice, perche extensible et mallette. Poids total environ 21 kg.

    L'application Tramex Meters est-elle incluse ?

    L'application Tramex Meters est téléchargeable gratuitement pour conserver et suivre les données de diagnostic depuis le CMEX5 et les sondes compatibles.

    Télécharger la fiche PDF

    Product Comments

    Comments (0)

    In the same category

    Verticam® HAD - Caméra inspection verticale Verticam® HAD - Caméra inspection verticale Verticam® HAD - Caméra inspection verticale

    Verticam® HAD V2 Compact - Vertical inspection camera

    HT €6,650.00
    TTC €7,980.00
    ( 0/5 )
      Caméra rotative Tubicam XL 360 HD AGM-TEC Caméra rotative Tubicam XL 360 HD AGM-TEC Caméra rotative Tubicam XL 360 HD AGM-TEC

      Tubicam® XL 360 HAD Compact - Rotating inspection camera with waterproof control

      HT €8,990.00
      TTC €10,788.00
      ( 0/5 )
        Foracam® Lite - Caméra inspection de forage

        Foracam® Lite - Drilling inspection camera

        HT €10,990.00
        TTC €13,188.00
        ( 0/5 )
          Tramex DEC SCANNER - Scanneur d'humidité toit terrasse. Tramex DEC SCANNER - Scanneur d'humidité toit terrasse. Tramex DEC SCANNER - Scanneur d'humidité toit terrasse.

          Tramex DEC SCANNER - Roof terrace humidity scanner.

          HT €7,250.00
          TTC €8,700.00
          ( 0/5 )
            Caméra d'inspection petit diamètre - Tubicam R 14 mm Caméra d'inspection petit diamètre - Tubicam R 14 mm Caméra d'inspection petit diamètre - Tubicam R 14 mm

            Tubicam® R 14 HD - Pool camera

            HT €2,090.00
            TTC €2,508.00
            ( 0/5 )
              Pile BR535 pour sonde

              BR535 battery for probe

              HT €73.00
              TTC €87.60
              ( 0/5 )
              • Out-of-Stock
              Foracam Foracam Foracam

              Foracam® v3

              HT €17,890.00
              TTC €21,468.00
              ( 0/5 )
                Caméra rotative Tubicam XL 360 HD AGM-TEC Caméra rotative Tubicam XL 360 HD AGM-TEC Caméra rotative Tubicam XL 360 HD AGM-TEC

                Tubicam® XL 360 HAD v2 - Rotating inspection camera

                HT €8,990.00
                TTC €10,788.00
                ( 0/5 )
                  Tramex DEC SCANNER - Scanneur d'humidité toit terrasse. Tramex DEC SCANNER - Scanneur d'humidité toit terrasse. Tramex DEC SCANNER - Scanneur d'humidité toit terrasse.

                  TRAMEX Roofing Master Pack - Roof terrace and wall humidity detection

                  HT €8,790.00
                  TTC €10,548.00
                  ( 0/5 )
                    Tubicam XL technologie fil d'eau et caméra 50 mm Tubicam XL technologie fil d'eau et caméra 50 mm Tubicam XL technologie fil d'eau et caméra 50 mm

                    Tubicam® XL HD - Ø40 mm inspection camera

                    HT €4,590.00
                    TTC €5,508.00
                    ( 0/5 )

                      Produits les plus populaires

                      Tubicam® Mini Rotative V2- Caméra de canalisations Tubicam® Mini Rotative V2- Caméra de canalisations Tubicam® Mini Rotative V2- Caméra de canalisations

                      Tubicam® Mini Rotative V2- Pipe camera

                      HT €5,390.00
                      TTC €6,468.00
                      ( 0/5 )
                        Caméra 14 mm Caméra 14 mm

                        Tubicam® - Ø14 mm swimming pool camera

                        HT €695.00
                        TTC €834.00
                        ( 5/5 )